PhD researcher on fully-integrated CMOS broadband receivers for imaging and bio-sensing applications

Leuven - PhD
More than two weeks ago
Apply for this job

Many bio-chemistry information on the frequency characteristic can be revealed at ~GHz  microwave frequencies. As shown in the figure below, the dielectric property of salt water has a huge transition in the frequency range of 1GHz to 10GHz. In such applications, the fully-integrated microwave receivers with a build-in frequency generation that can operate over a very wide frequency range (over 3 decades) are one of the most critical components of such systems. Standard CMOS technologies are used to reduce the cost of manufacturing and system integration, enabling the point-of-care diagnosis. However, the lossy and leaky substrate in CMOS process makes such broadband design very challenging.


In this PhD. project, the key design challenges of a CMOS microwave receiver covering a frequency range from a few tens of MHz up to 40GHz will be studied, and the prototype CMOS ICs will be developed. The resulting IC prototypes will also be tested in the real imaging and bio-sensing applications.

Required background: Solid background in RF and analog integrated circuit design, preferably with sufficient experience in tape-out (40nm preferred) and lab evaluation

Type of work: RF architecture innovation, RF integrated circuit design, co-develop system demonstrator

Supervisor: Piet Wambacq

Daily advisors: Yao-Hong Liu, Chengxun Liu

The reference code for this PhD position is SE1712-06. Mention this reference code on your application form.

Apply for this job

Share this on


This website uses cookies for analytics purposes only without any commercial intent. Find out more here. Our privacy statement can be found here. Some content (videos, iframes, forms,...) on this website will only appear when you have accepted the cookies.

Accept cookies